Under-dash Fuse/Relay Box Removal and Installation

Under-dash Fuse/Relay Box Removal and Installation

SRS components are located in this area. Review the SRS component locations, precautions, and procedures in the SRS section before performing repairs or service.

Removal

1.	Make sure you have the anti-theft codes for the radio and the navigation system, then write down the frequencies for the radio's preset buttons.

2.	Disconnect the battery negative cable, then disconnect the positive cable, and wait at least 3 minutes.

3.	Remove the left front door sill trim and left kick panel.

4.	Disconnect the connectors from the fuse side of the under-dash fuse/relay box (A).

5.	Remove the two mounting bolts and pull the fuse/relay box away from the body. A

6.	Disconnect the connectors and remove the under-dash fuse/relay box. NOTE: Some SRS harness connectors are spring-loaded lock type.

Installation

1.	Connect the connectors to the under-dash fuse/relay box, then install the under-dash fuse/relay box in the reverse order of removal.

2.	Install the removed parts in the reverse order of removal.

3.	Connect both the positive cable and negative cable to the battery.

4.	Do the ECM/PCM idle learn procedure.

5.	Do the power window control unit reset procedure.

6.	Enter the anti-theft codes for the radio and navigation system, then enter the customer's radio station presents.

7.	Confirm that all systems work properly.