Interior Trim Removal/Installation - Door Area (4D)

Interior Trim Removal/Installation - Door Area

SRS components are located in this area. Review the SRS component locations LHD, SRS components locations RHD and the precautions and procedures in the SRS section before performing repairs or service.

Without Side Curtain Airbag

NOTE:

• Put on gloves to protect your hands.
  
• When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
  
• Take care not to bend or scratch the trim and panels.
  
• LHD is shown; RHD is symmetrical.
  

1.	Remove the trim as shown:

2.

Install the trim in the reverse order of removal, and note these items: Replace any damaged clips. Push the clip portions into place securely. Apply liquid thread lock to the front seat belt upper anchor bolt before installation. Before installing the anchor bolts, make sure there are no twists or kinks in the belts. REAR DOOR OPENING TRIM[A] portions:FRONT DOOR OPENING TRIMFRONT SEAT BELT UPPER ANCHOR BOLT 7/16-20 UNF 32 N·m (3.3 kgf·m, 24 lbf·ft)HOOKDOOR OPENING TRIMFRONT PILLAR TRIMFRONT SIDE OUTER TRIMFRONT SIDE CAPOPENER LOCK CYLINDERLEFT KICK PANELRIGHT KICK PANELFRONT DOOR SILL TRIMCENTER PILLAR LOWER TRIMREAR DOOR SILL TRIMREAR SIDE OUTER TRIMUPPER ANCHOR COVERBABAAB[A](1)(2)AA[A]BDCBCENTER PILLAR UPPER TRIMBBCC[A]BDFastener LocationsB: Clip Left,7 Right,8C: Clip Left,3 Right,2D: Clip, 1A: Clip, 5

With Side Curtain Airbag

NOTE:

• Put on gloves to protect your hands.
  
• When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
  
• Take care not to bend or scratch the trim and panels.
  

1.	Remove the trim as shown:

2.

Install the trim in the reverse order of removal, and note these items: If the side curtain airbag have deployed, be sure to check the removed trim pieces for damage before reinstallation, and if necessary, replace them with new ones. If the side curtain airbag have not deployed, removed trim pieces should still be checked for damage, and replace them with new ones if necessary. Make sure the top of the trim overlaps with the headliner correctly. Make sure the trim hooks are installed into holes in the side curtain airbag center bracket securely. Push the clip portions into place securely. Apply liquid thread lock to the front seat belt upper anchor bolt before installation. Before installing the anchor bolts, make sure there are no twists or kinks in the belts. [A] portions:FRONT SEAT BELT UPPER ANCHOR BOLT 7/16-20 UNF 32 N·m (3.3 kgf·m, 24 lbf·ft)HOOKDOOR OPENING TRIMFRONT PILLAR TRIMFRONT SIDE CAPOPENER LOCK CYLINDERFRONT DOOR SILL TRIMCENTER PILLAR LOWER TRIMREAR DOOR OPENING TRIMUPPER ANCHOR COVER(1)(2)CENTER PILLAR UPPER TRIM[A]REAR DOOR SILL TRIMFRONT PILLAR TRIMFRONT PILLAR CAPHOOKSGROMMETHOOKSSIDE CURTAIN AIRBAG CENTER BRACKETABCBBBBBBAAAAFastener LocationsA: Clip, 5C: Clip, 1B: Clip, 7