Dashboard Center Pocket Removal and Installation

Dashboard Center Pocket Removal and Installation

SRS components are located in this area. Review the SRS component locations LHD, SRS components locations RHD and the precautions and procedures in the SRS section before performing repairs or service.

NOTE:

• Put on gloves to protect your hands.
  
• Take care not to scratch the dashboard and related parts.
  

1.	Remove the center holder.

2.

Remove the center pocket (A): -1  Remove the screw (B). -2  Open the lid, then pull the pocket back by hand to detach the clips (C). -3  Close the lid, then remove the pocket. Without navigation system and/or premium sound system: Fastener Locations: Screw, 2B: Clip, 2CEDABCBC With navigation system and/or premium sound system: Fastener Locations: Screw, 2B: Clip, 2CABCCB

3.	Install the pocket in the reverse order of removal, and make sure the holders (D) are installed onto the pins (E) properly (without navigation system and/or premium sound system).