| DTC P1733: | Problem in Shift Control System: |
| 1. | Warm up the engine to normal operating temperature (the radiator fan comes on). |
| 2. | Check to be sure that the transmission is filled to the proper level, and check for fluid leaks. |
| 3. | Check for deterioration in the quality of ATF. Has the ATF deteriorated? YES - Replace ATF, and test-drive the vehicle under the same conditions as those indicated by the freeze data, then recheck. NO - Go to 4. |
| 4. | Clear the DTC in CLEAR MENU with the Honda PGM Tester or HDS. |
| 5. | Select SHIFT SOL TEST in MISC. TEST MENU, then carry out A/T SHIFT SOL D test in SHIFT SOL TEST MENU with the Honda PGM Tester or HDS. Is a clicking sound heard? YES - Go to 6. NO - Faulty shift solenoid valve D, replace it. After replacing the solenoid valve, go to 11, and check that the repair has been completed. |
| 6. | Select LINEAR SOL TEST in MISC. TEST MENU, then carry out LINEAR SOL C TEST in LINEAR SOL TEST MENU. Is the system OK? YES - Go to 7. NO - Go to 10. |
| 7. | Test-drive the vehicle in the [D] position in all five gears at speeds over 10 mph (16 km/h) for 20 seconds, then slow down and stop the wheels. |
| 8. | Retest-drive the vehicle in the [D] position in all five gears at 10 mph (16 km/h) for 20 seconds. |
| 9. | Check the OBD STATUS in DTCs MENU for a pass/fail test of code P1733. Did the result fail? YES - Repair shift valve D, or replace the transmission.n NO - Intermittent failure, the system is OK at this time. If the tester indicates NOT COMPLETE, return to step 7 and recheck.n |
| 10. | Inspect A/T clutch pressure control solenoid valve C. Does A/T clutch pressure control solenoid valve C work properly? YES - Shift valves B and C may be stuck, repair hydraulic system related with shift valves B and C, or replace the transmission.n NO - Replace A/T clutch pressure control solenoid valve C. After replacing the solenoid valve, go to 11, and check that the repair has been completed. |
| 11. | Clear the DTC in CLEAR MENU with the Honda PGM Tester or HDS. |
| 12. | Test-drive the vehicle for several minutes under the same conditions as those indicated by the freeze data. |
| 13. | Check the OBD STATUS in DTCs MENU for a pass/fail test of code P1733. Did the result pass? YES - The problem has been corrected.n NO - Return to step 1 and recheck.n |