| 1. | Disconnect the A/T clutch pressure control solenoid valves B and C connectors. |
| 2. | Remove the A/T clutch pressure control solenoid valves B and C. |
| 3. | Remove the ATF joint pipes (D), O-rings (E), and gasket (A). |
| 4. | Clean the mounting surface and fluid passages of the A/T clutch pressure control solenoid valves B and C and transmission housing. |
| 5. | Install the new gasket on the transmission housing, and install the ATF joint pipes. |
| 6. | Install new O-rings over the ATF joint pipes. |
| 7. | Install new A/T clutch pressure control solenoid valves B and C. |
| 8. | Check A/T clutch pressure control solenoid valves B and C connectors for rust, dirt, or oil, then connect the connectors securely. |