| DTC P0797: | A/T Clutch Pressure Control Solenoid Valve C Stuck ON |
| 1. | Warm up the engine to normal operating temperature (the radiator fan comes on). |
| 2. | Check to be sure that the transmission is filled to the proper level, and check for fluid leaks. |
| 3. | Check for deterioration in the quality of ATF. Has the ATF deteriorated? YES - Replace ATF, and test-drive the vehicle under the same conditions as those indicated by the freeze data, then recheck. NO - Go to 4. |
| 4. | Clear the DTC in CLEAR MENU with the Honda PGM Tester or HDS. |
| 5. | Select LINEAR SOL TEST in MISC. TEST MENU, then carry out LINEAR SOL C TEST in LINEAR SOL TEST MENU. Is the system OK? YES - Intermittent failure, the system is OK at this time.n NO - Go to 6. |
| 6. | Inspect the A/T clutch pressure control solenoid valve C. Does the A/T clutch pressure control solenoid valve C work properly? YES - Shift valves B and C may be stuck, repair hydraulic system related with shift valves B and C, or replace the transmission.n NO - Replace the A/T clutch pressure control solenoid valve C. After replacing the solenoid valve, go to 7, and check that the repair has been completed. |
| 7. | Clear the DTC in CLEAR MENU with the Honda PGM Tester or HDS. |
| 8. | Test-drive the vehicle for several minutes under the same conditions as those indicated by the freeze data. |
| 9. | Check the OBD STATUS in DTCs MENU for a pass/fail test of code P0797. Did the result pass? YES - The problem has been corrected.n NO - Return to step 1 and recheck.n |