| 1. | Make sure you have the anti-theft codes for the radio and the navigation system, then write down the frequencies for the radio's preset buttons. |
| 2. | Disconnect the battery negative cable, then disconnect the positive cable, and wait at least 3 minutes. |
| 3. | Remove the left front door sill trim and left kick panel. |
| 4. | Disconnect the connectors from the fuse side of the under-dash fuse/relay box (A). |
| 5. | Remove the two mounting bolts and pull the fuse/relay box away from the body. |
| 6. | Disconnect the connectors and remove the under-dash fuse/relay box. NOTE: Some SRS harness connectors are spring-loaded lock type. |
| 1. | Connect the connectors to the under-dash fuse/relay box, then install the under-dash fuse/relay box in the reverse order of removal. |
| 2. | Install the removed parts in the reverse order of removal. |
| 3. | Connect both the positive cable and negative cable to the battery. |
| 4. | Do the ECM/PCM idle learn procedure. |
| 5. | Do the power window control unit reset procedure. |
| 6. | Enter the anti-theft codes for the radio and navigation system, then enter the customer's radio station presents. |
| 7. | Confirm that all systems work properly. |