| 1. | Before installing the steering wheel, make sure the front wheels are aligned straight ahead, then center the cable reel (A). Do this by first rotating the cable reel clockwise until it stops. Then rotate it counterclockwise about three turns. The arrow mark (B) on the cable reel label point should point straight up. |
| 2. | Position the two tabs (A) of the turn signal cancelling sleeve (B) as shown. Install the steering wheel on to the steering column shaft, making sure the steering wheel hub (C) engages the pins (D) of the cable reel and tabs of the canceling sleeve. Do not tap on the steering wheel or steering column shaft when installing the steering wheel. |
| 3. | Install the steering wheel bolt (A) and tighten it to the specified torque. Connect the cable reel sub cord connector to the cable reel. Make sure the wire harness is routed and fastened properly. |
| 4. | Install the driver's airbag, and confirm that the system is operating properly. |
| 5. | Do the idle learn procedure. |
| 6. | Perform the power window control unit reset procedure. |
| 7. | Enter the anti-theft codes for the radio, then enter the customer's radio station presets. Reset the clock. |
| 8. | Check the cruise control, audio remote and turn signal canceling for proper operation. |