| 1. | Disconnect the battery negative cable and wait at least 3 minutes before beginning work. |
| 2. | Remove the access panel (A) from the steering wheel, then disconnect the driver's airbag 2P connector (B) from the cable reel. |
| 3. | Remove the two Torx bolts (A) using a Torx T30 bit. |
| 4. | Disconnect the horn switch connector (1P), then remove the driver's airbag (B). |
| 1. | Connect the horn switch connector (1P) (A) to the driver's airbag. |
| 2. | Place the new driver's airbag (B) in the steering wheel, and secure it with new Torx bolts (C). |
| 3. | Connect the cable reel 2P connector (A) to the driver's airbag 2P connector, then install the access panel (B) on the steering wheel. |
| 4. | Connect the battery negative cable. |
| 5. | After installing the airbag, confirm proper system operation:
|