STEERING LINKAGE > REMOVAL

1. PRECAUTION

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

3. PLACE FRONT WHEEL FACING STRAIGHT AHEAD

4. REMOVE STERRING PAD ASSEMBLY

5. REMOVE STEERING WHEEL ASSEMBLY

6. REMOVE STEERING COLUMN COVER LOWER

7. REMOVE STEERING COLUMN COVER UPPER

8. REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY

9. REMOVE HEADLIGHT DIMMER SWITCH ASSEMBLY

10. REMOVE SPIRAL CABLE SUB-ASSEMBLY

11. REMOVE FRONT WHEEL

12. REMOVE NO. 2 ENGINE UNDER COVER (for 4WD)

13. REMOVE NO. 1 ENGINE UNDER COVER (for 4WD)

14. REMOVE FRONT SIDE MEMBER TO FRONT SUSPENSION CROSSMEMBER BRACE

15. REMOVE STABILIZER BAR FRONT

16. DISCONNECT TIE ROD END SUB-ASSEMBLY LH

17. DISCONNECT TIE ROD END SUB-ASSEMBLY RH

18. REMOVE NO. 2 STEERING INTERMEDIATE SHAFT SUB-ASSEMBLY

19. DISCONNECT PRESSURE FEED TUBE ASSEMBLY

20. DISCONNECT STEERING GEAR OUTLET RETURN TUBE

21. REMOVE POWER STEERING LINK ASSEMBLY