STEERING LINKAGE > INSTALLATION

1. INSTALL TIE ROD END SUB-ASSEMBLY LH

2. INSTALL TIE ROD END SUB-ASSEMBLY RH

3. INSTALL POWER STEERING LINK ASSEMBLY

4. INSTALL STABILIZER BAR FRONT

5. STABILIZE SUSPENSION

6. CONNECT STEERING GEAR OUTLET RETURN TUBE

7. CONNECT PRESSURE FEED TUBE ASSEMBLY

8. FULLY TIGHTEN NO. 2 STEERING INTERMEDIATE SHAFT SUB-ASSEMBLY

9. CONNECT TIE ROD END SUB-ASSEMBLY LH

10. CONNECT TIE ROD END SUB-ASSEMBLY RH

11. INSTALL FRONT SIDE MEMBER TO FRONT SUSPENSION CROSSMEMBER BRACE

12. INSTALL NO. 1 ENGINE UNDER COVER (for 4WD)

13. INSTALL NO. 2 ENGINE UNDER COVER (for 4WD)

14. INSTALL FRONT WHEEL

15. PLACE FRONT WHEELS FACING STRAIGHT AHEAD

16. INSTALL WINDSHIELD WIPER SWITCH ASSEMBLY

17. INSTALL HEADLIGHT DIMMER SWITCH ASSEMBLY

18. INSTALL SPIRAL CABLE SUB-ASSEMBLY

19. INSTALL STEERING COLUMN COVER UPR

20. INSTALL STEERING COLUMN COVER LWR

21. INSTALL STEERING WHEEL ASSEMBLY

22. INSPECT STEERING WHEEL CENTER POINT

23. INSTALL STEERING PAD ASSEMBLY

24. INSPECT STEERING PAD ASSEMBLY

25. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

26. PERFORM INITIALIZATION

27. INSPECT SRS WARNING LIGHT

28. ADD POWER STEERING FLUID

29. BLEED AIR FROM POWER STEERING SYSTEM

30. CHECK FOR POWER STEERING FLUID LEAKAGE

31. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT