VALVE CLEARANCE > ADJUSTMENT

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

3. REMOVE CHARGE AIR COOLER ASSEMBLY WITH INTAKE AIR CONNECTOR

4. LOOSEN FUEL TANK CAP ASSEMBLY

5. REMOVE INJECTION PIPE

6. REMOVE CYLINDER HEAD COVER SUB-ASSEMBLY

7. REMOVE INJECTOR ASSEMBLY

8. SET NO. 1 CYLINDER TO TDC/COMPRESSION

9. INSPECT VALVE CLEARANCE

10. ADJUST VALVE CLEARANCE

11. INSTALL INJECTOR ASSEMBLY

12. CHECK FOR FUEL LEAKS

13. INSTALL CYLINDER HEAD COVER SUB-ASSEMBLY

14. INSTALL INJECTION PIPE

15. INSTALL CHARGE AIR COOLER ASSEMBLY WITH INTAKE AIR CONNECTOR

16. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY

17. ADD FUEL

18. TIGHTEN FUEL TANK CAP ASSEMBLY

19. BLEED AIR FROM FUEL SYSTEM

20. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

21. PERFORM INITIALIZATION

22. CHECK FOR FUEL LEAKS

23. CHECK FOR ENGINE OIL LEAKS