AUTOMATIC TRANSMISSION ASSEMBLY > REMOVAL

1. DISCONNECT BATTERY TERMINAL

2. REMOVE NO. 2 FRAME CROSSMEMBER SUB-ASSEMBLY

3. DISCONNECT HEATED OXYGEN SENSOR

4. REMOVE EXHAUST PIPE

5. REMOVE FRONT PROPELLER SHAFT ASSEMBLY

6. REMOVE PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY

7. DRAIN AUTOMATIC TRANSMISSION FLUID

8. REMOVE MANIFOLD STAY

9. REMOVE NO. 2 MANIFOLD STAY

10. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY LH

11. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY RH

12. DISCONNECT OIL COOLER TUBE

13. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

14. REMOVE NO. 1 TRANSMISSION CONTROL CABLE BRACKET

15. SUPPORT AUTOMATIC TRANSMISSION ASSEMBLY

16. REMOVE NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY

17. REMOVE NO. 1 ENGINE MOUNTING INSULATOR REAR

18. DISCONNECT CONNECTOR

19. DISCONNECT WIRE HARNESS

20. REMOVE STARTER ASSEMBLY

21. REMOVE FLYWHEEL HOUSING SIDE COVER

22. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY

23. REMOVE TORQUE CONVERTER CLUTCH ASSEMBLY