MANUAL TRANSMISSION ASSEMBLY > INSTALLATION

1. INSTALL MANUAL TRANSMISSION UNIT ASSEMBLY

2. INSTALL STIFFENER PLATE (1KD-FTV)

3. INSTALL EXHAUST MANIFOLD STAY (for 2TR-FE)

4. INSTALL REAR NO. 1 ENGINE MOUNTING INSULATOR

5. INSTALL NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY

6. INSTALL STARTER ASSEMBLY

7. CONNECT CLUTCH RELEASE CYLINDER ASSEMBLY (for 1KD-FTV, 2TR-FE)

8. CONNECT CLUTCH RELEASE CYLINDER ASSEMBLY (1GR-FE)

9. CONNECT WIRE HARNESS

10. INSTALL FRONT EXHAUST PIPE ASSEMBLY

11. INSTALL REAR PROPELLER SHAFT ASSEMBLY

12. INSTALL NO. 2 FRAME CROSSMEMBER SUB-ASSEMBLY

13. ADD MANUAL TRANSMISSION OIL

14. INSTALL FLOOR SHIFT SHIFT LEVER ASSEMBLY

15. INSTALL SHIFT LEVER BOOT ASSEMBLY

16. INSTALL CONSOLE BOX ASSEMBLY

17. INSTALL UPPER CONSOLE PANEL ASSEMBLY

18. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY

19. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

20. PERFORM INITIALIZATION

21. CHECK SRS WARNING LIGHT

22. BLEED AIR FROM CLUTCH PIPE LINE (1GR-FE)

23. CHECK FOR CLUTCH FLUID LEAKAGE (1GR-FE)

24. INSPECT AND ADJUST CLUTCH PEDAL ASSEMBLY (1GR-FE)

25. CHECK FOR FLUID LEVEL IN RESERVOIR (1GR-FE)