AUTOMATIC TRANSMISSION ASSEMBLY > INSTALLATION

1. INSPECT TORQUE CONVERTER CLUTCH ASSEMBLY

2. INSTALL TORQUE CONVERTER CLUTCH ASSEMBLY

3. INSTALL TRANSFER ASSEMBLY

4. INSTALL NO. 1 ENGINE MOUNTING INSULATOR REAR

5. INSTALL AUTOMATIC TRANSMISSION ASSEMBLY

6. INSTALL STIFFENER PLATE

7. CONNECT WIRE HARNESS

8. CONNECT CONNECTOR

9. INSTALL NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY

10. INSTALL STARTER ASSEMBLY

11. INSTALL TRANSMISSION CONTROL CABLE BRACKET

12. CONNECT TRANSMISSION CONTROL SHIFT CABLE ASSEMBLY

13. INSTALL OIL COOLER TUBE

14. INSTALL TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY

15. INSTALL PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY

16. INSTALL FRONT PROPELLER SHAFT ASSEMBLY

17. INSTALL TRANSFER CASE LOWER PROTECTOR

18. INSTALL FRONT EXHAUST PIPE ASSEMBLY

19. INSTALL TRANSFER HIGH AND LOW SHIFT LEVER ASSEMBLY

20. INSTALL SHIFT LEVER BOOT ASSEMBLY

21. ADJUST SHIFT LEVER POSITION

22. ADD AUTOMATIC TRANSMISSION FLUID

23. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

24. PERFORM INITIALIZATION

25. INSPECT SHIFT LEVER POSITION

26. INSTALL CONSOLE BOX ASSEMBLY

27. CHECK FOR EXHAUST GAS LEAKS

28. INSPECT AUTOMATIC TRANSMISSION FLUID

29. INSTALL NO. 2 ENGINE UNDER COVER

30. INSTALL NO. 1 ENGINE UNDER COVER