REAR DIFFERENTIAL CARRIER ASSEMBLY > REASSEMBLY

1. ASSEMBLE DIFFERENTIAL CASE (for 2 Pinion Gear Type)

2. ASSEMBLE DIFFERENTIAL CASE (for LSD)

3. INSTALL DIFFERENTIAL RING GEAR

4. INSTALL REAR DIFFERENTIAL CASE BEARING

5. INSPECT DIFFERENTIAL RING GEAR RUNOUT

6. INSTALL REAR DIFFERENTIAL DUST DEFLECTOR

7. INSTALL REAR DRIVE PINION FRONT TAPERED ROLLER BEARING

8. INSTALL REAR DRIVE PINION REAR TAPERED ROLLER BEARING

9. INSTALL REAR DRIVE PINION REAR TAPERED ROLLER BEARING

10. ADJUST DIFFERENTIAL DRIVE PINION PRELOAD

11. INSTALL DIFFERENTIAL CASE ASSEMBLY

12. INSTALL REAR DIFFERENTIAL BEARING ADJUSTING NUT

13. INSPECT AND ADJUST BACKLASH DIFFERENTIAL RING GEAR AND DIFFERENTIAL DRIVE PINION

14. INSPECT TOTAL PRELOAD

15. INSPECT TOOTH CONTACT BETWEEN RING GEAR AND DRIVE PINION

16. REMOVE REAR DRIVE PINION NUT

17. REMOVE REAR DRIVE PINION COMPANION FLANGE SUB-ASSEMBLY

18. REMOVE REAR DIFFERENTIAL DRIVE PINION OIL SLINGER

19. REMOVE REAR DRIVE PINION FRONT TAPERED ROLLER BEARING

20. INSTALL REAR DIFFERENTIAL DRIVE PINION BEARING SPACER

21. INSTALL REAR DRIVE PINION FRONT TAPERED ROLLER BEARING

22. INSTALL REAR DIFFERENTIAL DRIVE PINION OIL SLINGER

23. INSTALL REAR DIFFERENTIAL CARRIER OIL SEAL

24. INSTALL REAR DRIVE PINION COMPANION FLANGE SUB-ASSEMBLY

25. INSPECT DRIVE PINION PRELOAD

26. INSPECT TOTAL PRELOAD

27. INSPECT DIFFERENTIAL RING GEAR BACKLASH

28. INSPECT RUNOUT OF REAR DRIVE PINION COMPANION FLANGE SUB-ASSEMBLY

29. STAKE DRIVE PINION NUT

30. INSTALL REAR DIFFERENTIAL BEARING ADJUSTING NUT LOCK