DTC Troubleshooting: 11-3x
| DTC 11-3x (11-30 to 11-39, 11-3A to 11-3F): | |
| | |
Special Tools Required
SRS inflator simulator ( 07SAZ-TB4011A)
SRS simulator lead C ( 07TAZ-SZ5011A)
SRS simulator lead F ( 07XAZ-SZ30100)
SRS short canceller ( 070AZ-SAA0100)
| 2. | Turn the ignition switch ON (II), and check that the SRS indicator comes on for about 6 seconds and then goes off.
Does the SRS indicator stay on and is DTC 11-3x indicated?
YES - Go to 3.
NO - Intermittent failure, system is OK at this time. Go to Troubleshooting Intermittent Failures. If another DTC is indicated, go to the DTC troubleshooting index for troubleshooting details.
|
| 3. | Turn the ignition switch OFF. Disconnect the battery negative cable, and wait for 3 minutes.
|
| 4. | Disconnect the driver's airbag 2P connector (A) from the cable reel.
 A07SAZ-TB4011A07TAZ-SZ5011A |
| 5. | Connect the SRS inflator simulator (2 W connector) and simulator lead C to the cable reel.
|
| 6. | Reconnect the battery negative cable.
|
| 9. | Turn the ignition switch OFF. Disconnect the battery negative cable, and wait for 3 minutes.
|
| 10. | Disconnect the dashboard wire harness 4P connector (A) from the cable reel.
 A07SAZ-TB4011A07XAZ-SZ30100 |
| 11. | Connect the SRS inflator simulator (2 W connectors) and simulator lead F to the dashboard wire harness.
|
| 12. | Reconnect the battery negative cable.
|
| 15. | Turn the ignition switch OFF. Disconnect the battery negative cable, and wait for 3 minutes.
|
| 16. | Disconnect SRS unit connector A (28P) from the SRS unit.
 A |
| 17. | Disconnect the SRS inflator simulator from SRS simulator lead F.
|
| 19. | Check resistance between the terminals of the SRS simulator lead F. There should be an open circuit, or at least 1 MW.
 DASHBOARD
WIRE HARNESS
4P CONNECTOR07XAZ-SZ30100Is the resistance as specified?
YES - Replace the the SRS unit.n
NO - Replace the dashboard wire harness.n |
