Wiper/Washer Switch Test/Replacement

KQ model:


1.Remove the dashboard lower cover.

2.Remove the steering column covers.

3.Disconnect the 12P connector (A) from the combination light switch (B).

4.Remove the two screws, then slide out the wiper/washer switch (A).

5.Inspect the connector terminals to be sure they are all making good contact.

  • If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
  • If the terminals look OK, check for continuity between the terminals in each switch position according to the tables.
    • If the continuity is not as specified, replace the switch.