| DTC P0711: | Problem in ATF Temperature Sensor Circuit |
| 1. | Check the ATF temperature with the Honda PGM Tester or HDS. Does the ATF temperature exceed the outside-air temperature? YES - Record the ATF temperature. Leave the engine off for more than 30 minutes, and go to 2. NO - Record the ATF temperature. Test the stall speed RPM three times. Go to 2 after stall speed testing. |
| 2. | Check the ATF temperature with the PGM Tester or HDS. Did the ATF temperature change? YES - Leave the engine off for more than 30 minutes, and go to 3. NO - Faulty ATF temperature sensor, replace it. After replacing the sensor, go to 5, and check that the repair has been completed. |
| 3. | Check the ECT SENSOR with the Honda PGM Tester or HDS. Is the ECT SENSOR equal to the outside-air temperature? YES - Go to 4. NO - Leave the engine off for more than 30 minutes, and return to step 3 and recheck.n |
| 4. | Check the ATF temperature with the Honda PGM Tester or HDS. Is the ATF temperature almost equal to ECT SENSOR? YES - Intermittent failure, the system is OK at this time.n NO - Faulty ATF temperature sensor, replace it. After replacing the sensor, go to 5, and check that the repair has been completed. |
| 5. | Clear the DTC in CLEAR MENUE with the Honda PGM Tester or HDS. |
| 6. | Test-drive the vehicle for several minutes under the same conditions as those indicated by the freeze data. |
| 7. | Check the OBD STATUS in DTCs MENU for a pass/fail test of code P0711. Did the result pass? YES - The problem has been corrected.n NO - Return to step 1 and recheck.n |