| DTC P1297: | ELD Circuit Low Voltage |
| 1. | Turn the ignition switch ON (II). |
| 2. | Check the ELD in the DATA LIST with the Honda PGM Tester or the HDS. Is 72A or more indicated? YES - Go to 3. NO - Intermittent failure, system is OK at this time. Check for poor connections or loose terminals at the ELD and the ECM/PCM.n |
| 3. | Turn the ignition switch OFF. |
| 4. | Disconnect the ELD 3P connector. |
| 5. | Turn the ignition switch ON (II). |
| 6. | Check the ELD in the DATA LIST with the Honda PGM Tester or the HDS. Is 72A or more indicated? YES - Go to 7. NO - Go to 11. |
| 7. | Turn the ignition switch OFF. |
| 8. | Jump the SCS line with the Honda PGM Tester or the HDS. |
| 9. | Disconnect ECM/PCM connector E (31P). |
| 10. | Check for continuity between ECM/PCM connector terminal E15 and body ground. Is there continuity? YES - Repair short in the wire between the ECM/PCM (E15) and the ELD, then go to 13. NO - Go to 19. |
| 11. | Turn the ignition switch OFF. |
| 12. | Replace the under-hood fuse/relay box. |
| 13. | Turn the ignition switch ON (II). |
| 14. | Do the ECM/PCM RESET in the CLEAR MENU with the Honda PGM Tester or the HDS. |
| 15. | Do the ECM/PCM idle learn procedure. |
| 16. | Start the engine. |
| 17. | Turn on the headlights. |
| 18. | Check for Temporary DTCs or DTCs in the DTCs MENU with the Honda PGM Tester or the HDS. Are any Temporary DTCs or DTCs indicated? YES - If DTC P1297 is indicated, check for poor connections or loose terminals at the ELD and the ECM/PCM, then go to 1. If any other Temporary DTCs or DTCs are indicated, go to the indicated DTC troubleshooting. NO - Troubleshooting is complete.n |
| 19. | Update the ECM/PCM if it does not have the latest software, or substitute a known-good ECM/PCM. |
| 20. | Start the engine. |
| 21. | Turn on the headlights. |
| 22. | Check for Temporary DTCs or DTCs in the DTCs MENU with the Honda PGM Tester or the HDS. Are any Temporary DTCs or DTCs indicated? YES - If DTC P1297 is indicated, check for poor connections or loose terminals at the ELD and the ECM/PCM, then go to 1. If any other Temporary DTCs or DTCs are indicated, go to the indicated DTC troubleshooting. NO - If the ECM/PCM was updated, troubleshooting was completed. If the ECM/PCM was substituted, replace the original ECM/PCM.n |