| 1. | Disconnect the battery negative cable, and wait at least 3 minutes before beginning work. |
| 2. | Disconnect the appropriate side airbag 2P connector. |
| 3. | Remove the seat assembly. |
| 4. | Remove the front door sill trim and the center pillar lower trim panel. |
| 5. | Disconnect the floor wire harness 2P connector from the side impact sensor (1st). |
| 6. | Remove the Torx bolts (A) using a Torx T30 bit, then remove the side impact sensor (1st) (B). |
| 1. | Install the new side impact sensor (1st) with Torx bolts (A), then connect the floor wire harness 2P connector (B) to the side impact sensor (1st). |
| 2. | Reconnect the battery negative cable. |
| 3. | After installing the side impact sensor (1st) confirm proper system operation: Turn the ignition switch ON (II); the SRS indicator should come on for about 6 seconds and then go off. |
| 4. | Install all removed parts. |