| 1. | Disconnect the battery negative cable and wait at least 3 minutes before beginning work. |
| 2. | Remove the glove box. |
| 3. | Disconnect the front passenger's airbag 2P connector (A) from dashboard wire harness. |
| 4. | Disconnect the passenger's front pillar trim. |
| 5. | Remove the three mounting nuts (A) from the bracket. Cover the lid and dashboard with a cloth, and pry carefully with a screwdriver to lift the front passenger's airbag (B) out of the dashboard. NOTE: The airbag lid has pawls on its side which attach it to the dashboard. |
| 1. | Place the new front passenger's airbag (A) into the dashboard. Tighten the front passenger's airbag mounting nuts (B). |
| 2. | Connect the front passenger's airbag 2P connector (A) to dashboard wire harness, then reinstall the glove box and passenger's front pillar trim. |
| 3. | Reconnect the battery negative cable. |
| 4. | After installing the airbag, confirm proper system operation: Turn the ignition switch ON (II); the SRS indicator should come on for about 6 seconds and then go off. |