| 1. | Remove old liquid gasket from the oil pan mating surfaces, bolts, and bolt holes. |
| 2. | Clean and dry the oil pan mating surfaces. |
| 3. | Apply liquid gasket, P/N 08C70-K0334M or 08C70-X0331S, evenly to the cylinder block mating surface of the oil pan and to the inner threads of the bolt holes. NOTE: Do not install the parts if 4 minutes or more have elapsed since applying liquid gasket. Instead, reapply liquid gasket after removing old residue. |
| 4. | Install the oil pan. |
| 5. | Tighten the bolts in two or three steps. In the final step, tighten all bolts, in sequence, to 12 N·m (1.2 kgf·m, 8.7 lbf·ft). |
| 6. | Install the stiffener. |
| 7. | If the engine is still in the vehicle, do the following steps. |
| 8. | Tighten the nuts securing the transmission lower front mount and transmission lower rear mount. |
| 9. | Install a new set ring on the end of the left side driveshaft, then install the driveshaft. Make sure each ring ‘‘clicks'' into place in the differential. |
| 10. | Connect the left side suspension lower arm ball joint. |
| 11. | Install the left side damper fork. |
| 12. | Connect the stabilizer links. |
| 13. | Lower the hoist. |
| 14. | Tighten the front mount bolt, then install the front mount stop. |
| 15. | Tighten the rear mount bolt, then install the rear mount stop. |
| 16. | Loosen the mount bolt, then install the transmission upper mount/bracket assembly, clutch line clamp bracket and ground cable (M/T). |
| 17. | Install the transmission upper mount, transmission upper bracket, and ground cable, then loosely install the transmission upper bracket plate (A/T). |
| 18. | Tighten the transmission upper mount bolt (M/T). |
| 19. | Tighten the transmission upper mount bracket plate mounting bolts, then tighten the transmission upper mount bolt (A/T). |
| 20. | Install the clutch slave cylinder and clutch line bracket mounting bolt (M/T) . |
| 21. | Install the battery base, then install the harness clamp and harness bracket. |
| 22. | Install the air cleaner housing . |
| 23. | Install the battery. Clean the battery posts and cable terminals with sandpaper, then assemble them and apply grease to prevent corrosion. |
| 24. | Perform the engine control module (ECM)/ powertrain control module (PCM) idle learn procedure, and power window control unit reset procedure. |
| 25. | Enter the anti-theft codes for the radio and the navigation system, then enter the customer's radio station presets. |
| 26. | Set the clock. |