ENGINE UNIT > DISASSEMBLY > Preparation
 | 09032-00100 | Oil Pan Seal Cutter |
 | 09202-70020 | Valve Spring Compressor |
 | (09202-00010) | Attachment |
 | 09213-54015 | Crankshaft Pulley Holding Tool |
 | (91651-60855) | Bolt |
 | 09228-07501 | Oil Filter Wrench |
 | 09330-00021 | Companion Flange Holding Tool |
 | 09950-50013 | Puller C Set |
 | (09951-05010) | Hanger 150 |
 | (09952-05010) | Slide Arm |
 | (09953-05010) | Center Bolt 100 |
 | (09954-05021) | Claw No.2 |
| Adhesive compound | |
| Angle gauge | |
| Brush | |
| Caliper gauge | |
| Carbine cutter (30°) | |
| Carbine cutter (45°) | |
| Carbine cutter (60°) | |
| Chain block | |
| Compression gauge | |
| Connecting rod aligner | |
| CO/HC meter | |
| Cylinder gauge | |
| Dial indicator | |
| Dial indicator with magnetic base | |
| Dye penetrant | |
| Engine tune-up tester | |
| Groove cleaning tool | |
| Heater | |
| Micrometer | |
| Pin hole grinder | |
| Piston ring expander | |
| Plastigage | |
| Precision straight edge | |
| Press | |
| Radiator cap tester | |
| Reamer (5.5 mm) | |
| Ridge reamer | |
| Sandpaper (#400) | |
| Slide caliper | |
| Soft brush | |
| Solvent | |
| Spring tester | |
| Steel square | |
| Straight edge | |
| Tachometer | |
| Thermometer | |
| Timing light | |
| Torque wrench | |
| "Torx" socket wrench | |
| Valve guide bush brush | |
| Valve seat cutter | |
| Vernier caliper | |
| V-block | |
| Wire brush | |
| Wooden block |
 | 09040-00011 | Hexagon Wrench Set | - |
 | (09043-20100) | Socket Hexagon Wrench 10 | - |
 | 09090-04020 | Engine Sling Device | - |
 | 08826-00080 | Seal Packing Black or equivalent (FIPG) | - |
 | 08833-00070 | Adhesive 1324, THREE BOND 1324 or equivalent | - |