SUN GEAR AND ONE-WAY CLUTCH > INSPECTION

for Preparation Click here



1. INSPECT ONE-WAY CLUTCH ASSEMBLY


AT08440E01

  1. Hold the planetary sun gear, and turn the one-way clutch assembly. Check that the one-way clutch hub can be turned freely clockwise and locks when turned counterclockwise.



2. INSPECT PLANETARY SUN GEAR


AT08337E01

  1. Using a dial indicator, measure the inside diameter of the planetary sun gear bushes.

    Maximum inside diameter:
    27.08 mm (1.0661 in.)

    If the inside diameter is greater than the maximum, replace the planetary sun gear.