POWER MIRROR CONTROL SYSTEM > INSPECTION

for Preparation Click here



1. INSPECT OUTER MIRROR SWITCH ASSEMBLY


B059702E03

  1. The L position of the left/right adjustment switch: Measure the resistance of the mirror switch.

    Standard (Left side):
    Tester Connection
    		Switch Condition
    		Specified Condition
    4 (MLV) - 8 (B)
    6 (M+) - 7 (E)
    		UP
    		Below 1 Ω
    4 (MLV) - 7 (E)
    6 (M+) - 8 (B)
    		DOWN
    		Below 1 Ω
    5 (MLH) - 8 (B)
    6 (M+) - 7 (E)
    		LEFT
    		Below 1 Ω
    5 (MLH) - 7 (E)
    6 (M+) - 8 (B)
    		RIGHT
    		Below 1 Ω

    If the result is not as specified, replace the switch assembly.

  1. The R position of the left/right adjustment switch: Measure the resistance of the mirror switch.

    Standard (Right side):
    Tester Connection
    		Switch Condition
    		Specified Condition
    3 (MRV) - 8 (B)
    6 (M+) - 7 (E)
    		UP
    		Below 1 Ω
    3 (MRV) - 7 (E)
    6 (M+) - 8 (B)
    		DOWN
    		Below 1 Ω
    2 (MRH) - 8 (B)
    6 (M+) - 7 (E)
    		LEFT
    		Below 1 Ω
    2 (MRH) - 7 (E)
    6 (M+) - 8 (B)
    		RIGHT
    		Below 1 Ω

    If the result is not as specified, replace the switch assembly.



2. INSPECT OUTER REAR VIEW MIRROR ASSEMBLY LH


B085125E01

  1. Disconnect the mirror connector.

  1. Apply battery voltage and check operation of the mirror.

    OK:
    Measurement Condition
    		Specified Condition
    Battery positive (+) →Terminal 5 (MV)
    Battery negative (-) → Terminal 3 (M+)
    		Turns upward (A)
    Battery positive (+) → Terminal 3 (M+)
    Battery negative (-) → Terminal 5 (MV)
    		Turns downward (B)
    Battery positive (+) → Terminal 1 (MH)
    Battery negative (-) → Terminal 3 (M+)
    		Turns left (C)
    Battery positive (+) → Terminal 3 (M+)
    Battery negative (-) → Terminal 1 (MH)
    		Turns right (D)

    If the result is not as specified, replace the mirror assembly.



3. INSPECT OUTER REAR VIEW MIRROR ASSEMBLY RH


B085124E01

  1. Disconnect the mirror connector.

  1. Apply battery voltage and check operation of the mirror.

    OK:
    Measurement Condition
    		Specified Condition
    Battery positive (+) → Terminal 5 (MV) Battery negative (-) → Terminal 3 (M+)
    		Turns upward (A)
    Battery positive (+) → Terminal 3 (M+) Battery negative (-) → Terminal 5 (MV)
    		Turns downward (B)
    Battery positive (+) → Terminal 1 (MH) Battery negative (-) → Terminal 3 (M+)
    		Turns left (C)
    Battery positive (+) → Terminal 3 (M+) Battery negative (-) → Terminal 1 (MH)
    		Turns right (D)

    If the result is not as specified, replace the mirror assembly.