INTERCOOLER > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY


    A110362

  1. Remove the 3 bolts, 2 nuts and cover.



3. REMOVE NO. 1 GAS FILTER


    A110363

  1. Remove the bolt and filter.



4. REMOVE MANIFOLD ABSOLUTE PRESSURE SENSOR


    A110364

  1. Disconnect the sensor connector.

  1. Remove the bolt and sensor.



5. REMOVE CHARGE AIR COOLER ASSEMBLY


    A110365

  1. Disconnect the diesel turbo IAT sensor connector.

  1. Loosen the 2 hose clamps of the No. 1 air hose.



    A110366

  1. Loosen the 2 hose clamps of the No. 2 air hose.



    A110367

  1. Remove the 4 bolts and CAC.



    A112149

  1. Using a 22 mm deep socket wrench, remove the IAT sensor.

    HINT:
    Replace the IAT sensor if it is deformed, cracked or malfunctioning. It is not necessary to replace the IAT sensor each time the CAC is replaced.



    A112150

  1. Remove the 4 bolts, intake air connector and gasket.