HEATED OXYGEN SENSOR (for Unleaded Gasoline Specification Vehicle) > INSTALLATION

for Preparation Click here



1. INSTALL HEATED OXYGEN SENSOR (2WD)


    A112121E01

  1. Using SST, install the sensor.

    SST
    09224-00010  

    Torque:
    44 N*m{ 449 kgf*cm , 32 ft.*lbf }

    Torque:
    40 N*m{ 408 kgf*cm , 30 ft.*lbf } for use with SST

    HINT:
    Use a torque wrench with a fulcrum length of 30 cm (11.81 in.).



    A112117

  1. Connect the sensor connector.



2. INSTALL HEATED OXYGEN SENSOR (4WD)


    A112121E02

  1. Using SST, install the sensor.

    SST
    09224-00010  

    Torque:
    44 N*m{ 449 kgf*cm , 32 ft.*lbf }

    Torque:
    40 N*m{ 408 kgf*cm , 30 ft.*lbf } for use with SST

    HINT:
    Use a torque wrench with a fulcrum length of 30 cm (11.81 in.).



    A112094

  1. Attach the 3 wire clamps to the vehicle body.

  1. Connect the sensor connector.



3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


4. PERFORM INITIALIZATION

  1. Perform initialization (Click here).

    CAUTION:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.