FUEL FILTER > INSPECTION

for Preparation Click here



1. INSPECT LEVEL WARNING SWITCH


A098950E01

  1. Measure the resistance of the switch.

    Standard resistance:
    Tester Connection
    		Switch Condition
    		Specified Condition
    1 - 2
    		ON
    		Below 1 Ω
    1 - 2
    		OFF
    		10 kΩ or higher

    If the result is not as specified, replace the fuel filter.



2. INSPECT CLOGGING SWITCH


A098961E01

  1. Measure the resistance between the terminals.

    Standard resistance:
    Below 1 Ω at 20°C (68°F)

    If the result is not as specified, replace the fuel filter.