INTAKE AIR TEMPERATURE SENSOR > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE ENGINE COVER SUB-ASSEMBLY


A111785

  1. Remove the 3 bolts, 2 nuts and cover.



3. REMOVE INTAKE AIR TEMPERATURE SENSOR

  1. Disconnect the IAT sensor connector.



    A098791

  1. Using a 22 mm deep socket wrench, remove the IAT sensor.

    HINT:
    Replace the IAT sensor if it is deformed, cracked or malfunctioning. It is not necessary to replace the IAT sensor each time the CAC is replaced.