INTAKE AIR TEMPERATURE SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL INTAKE AIR TEMPERATURE SENSOR


    A098791

  1. Using a 22 mm deep socket wrench, install a new gasket and the IAT sensor.

    Torque:
    29 N*m{ 296 kgf*cm , 21 ft.*lbf }

  1. Connect the IAT sensor connector.



2. INSTALL ENGINE COVER SUB-ASSEMBLY


A111785

  1. Install the cover with the 3 bolts and 2 nuts.

    Torque:
    7.0 N*m{ 71 kgf*cm , 62 in.*lbf }



3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


4. PERFORM INITIALIZATION

  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.