POWER DOOR LOCK CONTROL SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING


HINT:
Use these procedures to troubleshoot the power door lock control system.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE

      Standard:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.

    NEXT


    3.PROBLEM SYMPTOMS TABLE

      Result: 
      Result
      		Proceed to
      Fault is not listed in problem symptoms table
      		A
      Fault is listed in problem symptoms table
      		B


    		B.
    Go to step 5
    A


    4.OVERALL ANALYSIS AND TROUBLESHOOTING

    1. Terminals of ECU (Click here)

    2. On-vehicle Inspection (Click here)


    NEXT


    5.ADJUST, REPAIR OR REPLACE

      NEXT


      6.CONFIRMATION TEST

        NEXT

        END