RADIO RECEIVER > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE HEATER CONTROL KNOB


B088680E02

  1. Remove the 3 control knobs.



3. REMOVE FRE/REC CONTROL KNOB


B111103E01

  1. Remove the control knob.



4. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY CENTER


B113048E01

HINT:
To prevent the clips from falling, horizontally pull out the panel. Hold both sides of the panel in the locations indicated by the arrows in the illustration.

  1. Remove the screw <C>.

  1. Detach the 6 claws and 4 clips.

  1. NOTICE:
    Make sure the center registers are not removed.

    Disconnect all connectors and remove the panel.



5. REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET


    B112964

  1. Remove the 4 screws.

  1. Disconnect all connectors and remove the radio receiver.



    B085607

  1. w/o Stereo opening cover:
    Remove the No. 1 radio bracket.

    1. Remove the 4 screws and radio bracket from the radio receiver.



    B085608

  1. w/o Stereo opening cover:
    Remove the No. 2 radio bracket.

    1. Remove the 4 screws and radio bracket from the radio receiver.



    B112965

  1. w/ Stereo opening cover:
    Remove the No. 1 radio bracket.

    1. Remove the 4 screws and radio bracket from the radio receiver.



    B112966

  1. w/ Stereo opening cover:
    Remove the No. 2 radio bracket.

    1. Remove the 4 screws and radio bracket from the radio receiver.