FRONT DOOR LOCK > ON-VEHICLE INSPECTION



1. INSPECT FRONT DOOR LOCK ASSEMBLY (DRIVER SIDE)


B111989E01

  1. Apply battery voltage to the door lock and check operation of the door lock motor.

    OK:
    Measurement Condition
    		Specified Condition
    Battery positive (+) → Terminal 4
    Battery negative (-) → Terminal 1
    		Lock
    Battery negative (+) → Terminal 1
    Battery positive (-) → Terminal 4
    		Unlock

    1. If the result is not as specified, replace the door lock assembly.



    B111990E02

  1. Measure the resistance of the door lock and unlock switch.

    Standard resistance:
    LHD:
    Tester Connection
    		Door Lock Condition
    		Specified Condition
    7 - 9
    		Lock
    		Below 1 Ω
    7 - 9, 7 - 10
    		OFF
    		10 kΩor higher
    7 - 10
    		Unlock
    		Below 1 Ω
    RHD:
    Tester Connection
    		Door Lock Condition
    		Specified Condition
    6 - 8
    		Lock
    		Below 1 Ω
    5 - 8, 6- 8
    		OFF
    		10 kΩor higher
    5 - 8
    		Unlock
    		Below 1 Ω

    1. If the result is not as specified, replace the door lock assembly.

  1. w/ Wireless door lock system:
    Measure the resistance of the position switch.

    Standard resistance:
    Tester Connection
    		Switch Condition
    		Specified Condition
    7 - 8
    		Lock
    		10 kΩ or higher
    7 - 8
    		Unlock
    		Below 1 Ω

    1. If the result is not as specified, replace the door lock assembly.



2. INSPECT FRONT DOOR LOCK ASSEMBLY (PASSENGER SIDE)


B111996E01

  1. Apply battery voltage to the door lock and check operation of the door lock motor.

    OK:
    Measurement Condition
    		Specified Condition
    Battery positive (+) → Terminal 4
    Battery negative (-) → Terminal 1
    		Lock
    Battery negative (+) → Terminal 1
    Battery positive (-) → Terminal 4
    		Unlock

    1. If the result is not as specified, replace the door lock assembly.