INTEGRATION RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. CHECK INTEGRATION RELAY


    G038997E01
    A112973

  1. Using a screwdriver, detach the 2 claws and disconnect the integration relay from the engine room junction block.

    HINT:
    Tape the screwdriver tip before use.


    1. Measure the voltage of the C/OPN relay.

      Standard resistance:
      Tester Connection
      		Condition
      		Specified Condition
      IJ-8 - Body ground
      		Ignition switch ON
      		10 to 14 V

      If the result is not as specified, replace the integration relay.



      2. A112973

    2. Measure the voltage of the MAIN relay.

      Standard resistance:
      Tester Connection
      		Condition
      		Specified Condition
      IJ-4 - Body ground
      		Ignition switch ON
      		10 to 14 V

      If the result is not as specified, replace the integration relay.