INTEGRATION RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT INTEGRATION RELAY


    G038997

  1. Using a screwdriver, detach the 2 claws and disconnect the integration relay from the engine room junction block.

    HINT:
    Tape the screwdriver tip before use.




      G039047E12

    1. Measure the voltage of the EDU relay.

      Standard resistance:
      Tester Connection
      		Condition
      		Specified Condition
      IJ-8 - Body ground
      		Ignition switch ON
      		10 to 14 V

      If the result is not as specified, replace the integration relay.



      2. G039047E12

    2. Measure the voltage of the MAIN relay.

      Standard resistance:
      Tester Connection
      		Condition
      		Specified Condition
      IJ-4 - Body ground
      		Ignition switch ON
      		10 to 14 V

      If the result is not as specified, replace the integration relay.