HAZARD WARNING SWITCH > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH and LH sides.
  2. The procedures listed below are for the LH side.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY CENTER


B113048E01

HINT:
To prevent the clips from falling, horizontally pull out the panel. Hold both sides of the panel in the locations indicated by the arrows in the illustration.

  1. Remove the screw <C>.

  1. Detach the 6 claws and 4 clips.

  1. NOTICE:
    Make sure the center registers are not removed.

    Disconnect all connectors and remove the panel.



3. REMOVE HEATER CONTROL KNOB


B088680E02

  1. Remove the 3 control knobs.



4. REMOVE FRE/REC CONTROL KNOB


B111103E01

  1. Remove the control knob.



5. REMOVE HAZARD WARNING SIGNAL SWITCH ASSEMBLY


B113570E01

  1. Detach the 2 claws and remove the switch.