HAZARD WARNING SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL HAZARD WARNING SIGNAL SWITCH ASSEMBLY


B113570E01

  1. Install the switch to attach the 2 claws.



2. INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY CENTER


B113049E01

  1. Connect all connectors.

  1. Attach the 6 claws and 4 clips to install the panel.

  1. Install the panel with the screw <C>.



3. INSTALL FRE/REC CONTROL KNOB


B111103E02

  1. Install the control knob.



4. INSTALL HEATER CONTROL KNOB


B088680E02

  1. Install the 3 control knobs.



5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


6. PERFORM INITIALIZATION

  1. Perform initialization (Click here ).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.