FRONT DOOR BELT MOULDING > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)


3. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH


4. REMOVE DOOR PULL HANDLE


5. REMOVE FRONT ARMREST BASE PANEL UPPER LH (w/ Power Window)


6. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH


7. REMOVE OUTER REAR VIEW MIRROR SUB-ASSEMBLY LH


8. REMOVE FRONT DOOR BELT MOULDING ASSEMBLY LH

  1. Put protective tape under the moulding.



  1. Using a moulding remover, pry out the moulding as shown in the illustration.

    HINT:
    Tape the remover tip before use.

    NOTICE:
    Be careful when removing the moulding as there are claws attached to the moulding.



    B115406E01