REAR DOOR BELT MOULDING > REMOVAL

for Preparation Click here




1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)


3. REMOVE DOOR PULL HANDLE


4. REMOVE REAR DOOR ARMREST BASE PANEL UPPER LH (w/ Power Window)


5. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH


6. REMOVE REAR DOOR BELT MOULDING ASSEMBLY LH


B086092E01

  1. Put protective tape under the moulding.

  1. Using a moulding remover, pry out the moulding as shown in the illustration.

    HINT:
    Tape the remover tip before use.

    NOTICE:
    Be careful when removing the moulding as there are claws attached to the the moulding.