AIR FUEL RATIO SENSOR (for Sensor 1) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE V-BANK COVER

  1. Remove 2 nuts and cover.



3. REMOVE AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)


A112025E01

  1. Disconnect the sensor connector.

  1. Using SST, remove the sensor from the exhaust manifold.

    SST
    09224-00010  



4. REMOVE AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1)


A112027E01

  1. Disconnect the sensor connector.

  1. Using SST, remove the sensor from the exhaust manifold.

    SST
    09224-00010