VENTILATION VALVE > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE V-BANK COVER

  1. Remove the 2 nuts and cover.



3. REMOVE INTAKE AIR SURGE TANK


    A075597E01

  1. Disconnect the No. 5 water by-pass hose.



    A075598E01

  1. Disconnect the No. 4 water by-pass hose.



    A075644E01

  1. Disconnect the fuel vapor feed hose assembly.



    A075645E01

  1. Disconnect the ventilation hose.



    A075646E01

  1. Disconnect the 2 VSV connectors.

  1. Disconnect the throttle motor connector.

  1. Remove the 3 wire harness clamps and hose clamp.



    A075647E01

  1. Remove the 3 upper bolts, which are used to secure the 2 surge tank stays and throttle body bracket.



    A075648E01

  1. Using an 8 mm hexagon wrench, remove the 4 bolts.

  1. Remove the 2 nuts, intake air surge tank and gasket.



4. REMOVE VENTILATION VALVE SUB-ASSEMBLY


A112001

  1. Loosen the hose clamp and disconnect the ventilation hose from the valve.

  1. Remove the valve.