FUEL TEMPERATURE SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL FUEL TEMPERATURE SENSOR


A098438E05

  1. Using a 19 mm deep socket wrench, install the sensor.

    Torque:
    22 N*m{ 224 kgf*cm , 16 ft.*lbf }

  1. Connect the connector.



2. ADD FUEL


3. BLEED AIR FROM FUEL SYSTEM


A098962E01

  1. Using the hand pump, bleed air from the fuel system until pumping becomes difficult.



4. CONNECT BATTERY TO NEGATIVE BATTERY TERMINAL


5. PERFORM INITIALIZATION

  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.



6. CHECK FOR FUEL LEAKS