IGNITION KEY CYLINDER LIGHT > INSTALLATION |
| 1. INSTALL TRANSPONDER KEY AMPLIFIER |
![]() |
Using a screwdriver, widen the claw hanging onto the upper bracket by approximately 1.0 mm (0.039 in.).
Pull out the transponder key amplifier with the claw open.
| 2. INSTALL STEERING COLUMN COVER UPPER |
![]() |
Install the cover lower with the 3 screws.
| 3. INSTALL STEERING COLUMN COVER LOWER |
![]() |
Install the cover lower with the 3 screws.
| 4. INSTALL STEERING WHEEL ASSEMBLY |
![]() |
Align the matchmarks on the steering wheel and main shaft.
Install the steering set nut.
| 5. PLACE FRONT WHEELS FACING STRAIGHT AHEAD |
| 6. INSPECT STEERING WHEEL CENTER POINT |
| 7. INSTALL STEERING PAD ASSEMBLY |
![]() |
Straighten the front wheels.
Using a T30 "torx" socket, loosen the 2 screws until the groove along each screw circumference catches on the screw case.
![]() |
Pull out the steering pad from the steering wheel and support the steering pad with one hand as shown in the illustration.
Using a screwdriver, disconnect the airbag connector.
Disconnect the horn connector and remove the steering pad.
| 8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 9. INSPECT STEERING PAD ASSEMBLY |
Check for cuts, cracks or discoloration on the steering pad outer surface and in the grooved portion.
Check that the horn sounds.
| 10. PERFORM INITIALIZATION |
Perform initialization (Click here ).
| 11. CHECK SRS WARNING LIGHT |
Check the SRS warning light (Click here).