DRIVE BELT > INSPECTION

for Preparation Click here



1. INSPECT FAN AND GENERATOR V BELT


A054229E01

NOTICE:
It is unnecessary to measure the tension and flexibility of the V belt due to the adoption of the V belt automatic tensioner.

  1. Make sure that the belt tensioner's indicator is within range B.
    If the mark is not in range B, replace the V belt.

    HINT:
    1. After the replacement of the V belt, make sure that the belt tensioner's indicator is within range A.

    2. A087787E03
      After installing the V belt, check that it fits properly in the ribbed grooves. Check with your hand to confirm that the belt has not slipped out of the grooves on the bottom of the crank pulley.
    3. A "new belt" is a belt which has been used for less than 5 minutes on a running engine.
    4. A "used belt" is a belt which has been used on a running engine for 5 minutes or more.
    5. After installing a new belt, run the engine for approximately 5 minutes and then recheck the tension.