RADIATOR > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE NO. 1 ENGINE UNDER COVER

  1. Remove the 4 bolts and cover.



3. REMOVE RADIATOR GRILLE


B085203E01

  1. Using a clip remover, remove the 2 clips.

  1. Remove the 2 screws.

  1. Pull the radiator grille in the direction indicated by the arrow in the illustration to detach the 5 claws and remove the radiator grille.



4. REMOVE RADIATOR SIDE DEFLECTOR LH


    A112159

  1. Using a clip remover, remove the 2 clips.

  1. Detach the claw and remove the deflector.



5. REMOVE RADIATOR SIDE DEFLECTOR RH

  1. Using a clip remover, remove the 2 clips.

  1. Detach the claw and remove the deflector.



6. DRAIN ENGINE COOLANT


7. DISCONNECT RADIATOR HOSE INLET


8. DISCONNECT RADIATOR HOSE OUTLET


9. DISCONNECT NO. 1 OIL COOLER INLET TUBE (for Automatic Transmission)

  1. Disconnect the inlet tube from radiator tank lower.



10. DISCONNECT NO. 1 OIL COOLER OUTLET TUBE (for Automatic Transmission)

  1. Disconnect the outlet tube from radiator tank lower.



11. REMOVE FAN SHROUD


    A110406

  1. Remove the 3 bolts and oil reservoir.

  1. Disconnect the reservoir hose from the radiator tank upper.

  1. Loosen the 4 nuts holding the fluid coupling fan.

  1. Remove the drive belt (Click here).

  1. Remove the 2 bolts holding the fan shroud.

  1. Remove the 4 nuts of the fluid coupling fan, and then remove the shroud together with the fluid coupling fan.

    NOTICE:
    Be careful not to damage the radiator core.

  1. Remove the fan pulley from the water pump.



12. REMOVE RADIATOR ASSEMBLY


    A112139

  1. Disconnect the 2 front airbag sensor connectors.

  1. Using a clip remover, detach the 4 clamps from the radiator side as shown in the illustration.

    HINT:
    Tape the clip remover tip before use.



    A112140

  1. Remove the 4 bolts and radiator.