RADIATOR > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE RADIATOR GRILLE


B085203E01

  1. Using a clip remover, remove the 2 clips.

  1. Remove the 2 screws.

  1. Pull the radiator grille in the direction indicated by the arrow in the illustration to detach the 5 claws and remove the radiator grille.



3. REMOVE RADIATOR SIDE DEFLECTOR LH


    A110373

  1. Using a clip remover, remove the 2 clips.

  1. Detach the claws and remove the deflector.



4. REMOVE RADIATOR SIDE DEFLECTOR RH

  1. Using a clip remover, remove the 2 clips.

  1. Detach the claws and remove the deflector.



5. REMOVE NO. 1 ENGINE UNDER COVER

  1. Remove the 4 bolts and No. 1 under cover.



6. DRAIN ENGINE COOLANT

  1. Remove the radiator cap.



  1. Loosen the cylinder block drain cock plug and radiator drain plug, and then drain the coolant.

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.



    A112146E01



7. REMOVE RADIATOR HOSE INLET


8. REMOVE RADIATOR HOSE OUTLET


9. REMOVE AIR PUMP INLET (for Unleaded Gasoline Specification Vehicle)


A099954E01

  1. Remove the bolts and disconnect the pump inlet.



10. REMOVE FAN SHROUD


A099963E02

  1. Disconnect the reservoir hose from the radiator tank upper.

  1. Loosen the 4 nuts holding the fluid coupling fan.

  1. Remove the drive belt (Click here).

  1. Remove the 2 bolts holding the fan shroud.

  1. Remove the 4 nuts the fluid coupling fan, and then remove the shroud together with the coupling fan.

    NOTICE:
    Be careful not to damage the radiator core.

  1. Remove the fan pulley from the water pump.



11. DISCONNECT NO. 1 OIL COOLER TUBE INLET (for Automatic Transmission)

  1. Disconnect the inlet tube from the radiator.



12. DISCONNECT NO. 1 OIL COOLER TUBE OUTLET (for Automatic Transmission)

  1. Disconnect the outlet tube from the radiator.



13. REMOVE RADIATOR ASSEMBLY


    A110375

  1. Disconnect the 2 airbag sensor front connectors.

  1. Using a clip remover, detach the 4 clamps from the radiator side as shown in the illustration.

    HINT:
    Tape the clip remover tip before use.



    A099640E01

  1. Remove the 4 bolts and radiator.