IGNITION SWITCH > INSPECTION

for Preparation Click here



1. INSPECT IGNITION OR STARTER SWITCH ASSEMBLY


G035048E03

  1. Measure the resistance of the switch.

    Standard resistance:
    Tester Connection
    		Switch Condition
    		Specified Condition
    -
    		LOCK
    		10 kΩ or higher
    2 (ACC) - 4 (AM1)
    		ACC
    		Below 1 Ω
    1 (IG1) - 4 (AM1)
    2 (ACC) - 4 (AM1)
    5 (AM2) - 6 (IG2)
    		ON
    		Below 1 Ω
    1 (IG1) - 4 (AM1)
    2 (ACC) - 4 (AM1)
    5 (AM2) - 6 (IG2)
    5 (AM2) - 7 (ST2)
    		START
    		Below 1 Ω

    If the result is not as specified, replace the ignition switch assembly.