ACCELERATOR PEDAL ROD > INSTALLATION

for Preparation Click here



1. INSTALL ACCELERATOR PEDAL ROD ASSEMBLY


A098860E01

  1. Install the pedal rod with the 2 bolts.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }

  1. Connect the accelerator position sensor connector.



2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


3. PERFORM INITIALIZATION

  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.