CRANKSHAFT POSITION SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL CRANK SHAFT POSITION SENSOR

  1. Apply a light coat of engine oil to the O-ring of the sensor.



  1. Install the sensor with the bolt.

    Torque:
    8.5 N*m{ 87 kgf*cm , 75 in.*lbf }



    A112049

  1. Install the 4 clips and connect the sensor connector.



2. INSTALL NO. 2 ENGINE UNDER COVER


3. INSTALL NO. 1 ENGINE UNDER COVER


4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


5. PERFORM INITIALIZATION

  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.